Full Retention Separators

Full retention separators treat the full flow that can be delivered by the drainage system, which is normally equivalent to the flow generated by a rainfall intensity of 65mm/hr. On large sites, some short term flooding may be an acceptable means of limiting the flow rate and hence the size of full retention systems.

The Environment Regulators, Environment Agency, England and Wales, SEPA, Scottish Environmental Protection Agency in Scotland and Department of Environment & Heritage in Northern Ireland, have published guidance on surface water disposal, which offers a range of means of dealing with pollution both at source and at the point of discharge from site (so called ‘end of pipe’ treatment). These techniques are known as ‘Sustainable Drainage Systems’ (SuDS).

Where run-off is draining from relatively low risk areas such as car-parks and non-operational areas, a source control approach, such as permeable surfaces or infiltration trenches, may offer a suitable means of treatment, removing the need for a separator.

Oil separators are installed on surface water drainage systems to protect receiving waters from pollution by oil, which may be present due to minor leaks from vehicles and plant, from accidental spillage.

Effluent from industrial processes and vehicle washing should normally be discharged to the foul sewer (subject to the approval of the sewerage undertaker) for further treatment at a municipal treatment works.

Separator Standards and Types

A British (and European) standard (BS EN 858-1 and 858-2) for the design and use of prefabricated oil separators has been adopted. New prefabricated separators should comply with the standard.

Separator Classes

The standard refers to two ‘classes’ of separator, based on performance under standard test conditions.

Class I

Designed to achieve a concentration of less than 5mg/l of oil under standard test conditions, should be used when the separator is required to remove very small oil droplets.

Class II

Designed to achieve a concentration of less than 100mg/l oil under standard test conditions and are suitable for dealing with discharges where a lower quality requirement applies (for example where the effluent passes to foul sewer).

Both classes can be produced as full retention or bypass separators. The oil concentration limits of 5 mg/l and 100 mg/l are only applicable under standard test conditions. It should not be expected that separators will comply with these limits when operating under field conditions.

Display: List / Grid
Show:
Sort By:
Conder Full Retention Separator for Areas up to 222 sq/m
The CNS4S/11 is suitable for an area of up to 222 Class 1 inc Silt trap Full retention se..
£1,014.00 £925.20
Ex Tax: £771.00
Conder Full Retention Separator for Areas up to 333 sq/m
The CNS6S/11 is suitable for an area of up to 333 Class 1 inc Silt trap Full retention se..
£1,164.00 £1,033.20
Ex Tax: £861.00
Conder Full Retention Separator for Areas up to 444 sq/m
The CNS8S/11 is suitable for an area of up to 444 Class 1 inc Silt trap Full retention se..
£1,236.00 £1,128.00
Ex Tax: £940.00
Conder Full Retention Separator for Areas up to 556 sq/m
The CNS10S/11 is suitable for an area of up to 556 Class 1 inc Silt trap Full retention s..
£1,614.00 £1,431.60
Ex Tax: £1,193.00
Conder Full Retention Separator for Areas up to 833 sq/m
The CNS15S/11 is suitable for an area of up to 833 Class 1 inc Silt trap Full retention s..
£1,890.00 £1,730.40
Ex Tax: £1,442.00
Conder Full Retention Separator for Areas up to 1111 sq/m
The CNS20S/11 is suitable for an area of up to 1111 Class 1 inc Silt trap Full retention ..
£2,398.80
Ex Tax: £1,999.00
Klargester Full Retention Separator - 170 sq/m
APPLICATION Full retention separators are used in high risk spillage areas such as: F..
£822.00
Ex Tax: £685.00
Klargester Full Retention Separator - 335 sq/m
APPLICATION Full retention separators are used in high risk spillage areas such as: F..
£990.00
Ex Tax: £825.00
Klargester Full Retention Separator - 555 sq/m
APPLICATION Full retention separators are used in high risk spillage areas such as: F..
£1,314.00
Ex Tax: £1,095.00
Klargester Full Retention Separator - 835 sq/m
APPLICATION Full retention separators are used in high risk spillage areas such as: F..
£1,656.00
Ex Tax: £1,380.00
Klargester Full Retention Separator - 1115 sq/m
APPLICATION Full retention separators are used in high risk spillage areas such as: F..
£2,298.00
Ex Tax: £1,915.00
Powered By OpenCart
Septic Tank Supplies © 2016
SSL Certificates